Break in procedure for band saw blade made by Honsberg Metallsägen GmbH in Germany, for Bandsaw from Amada, Behringer and Daito
Band Sww Blades Technics for Cosem, Amada and Behringer
Band saw blades for Armade, Behringer and Casto

 

 

Here you can find out how to retract the band saw blades from Honsberg GmbH in Remscheid.

Life-time of band saw blades mainly depends on a controlled break-in. We recomme the following break-in procedure:

  • 1st step
    Select the correct speed Vc (m/min) and cutting rate Vz (cm /min) based on cutting conditions chart.

  • 2st step
    You start with 70% of the regular cutting speed and 50% of the regular cutting rate.

  • 3st step
    If vibrations still occur, change the speed carefully until the vibrations stop. A permanent chip formation is important during the whole cutting process.

  • 4st step
    After cutting approx. 400-600 cm2 or at least 15 minutes real cutting time for tubes and profiles you can first slowly turn up to the final speed and then up to the normal cutting rate.

 

 

 

Kontakt 
Auf dem Knapp 42
42855 Remscheid | Germany
Telefonnummer der Firma Honsber in Remscheid - Hersteller von Bandsägebändern - Band Sas Blades    +49 2191 373-770 
Faxnummer von Honsberg Metallsägen in Remscheid - Hersteller von Bandsägeblättern - Band Saw Blades    +49 2191 373-799
    info@honsberg.de
Internet    www.honsberg.de
Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.
More information Ok